Looking for Burbank Fence Contractor? Fences take a beating in Southern California sun, wind and irrigation. Posts, rails, boards, panels and gates, in every common fencing material. We serve Burbank and the surrounding Los Angeles County neighborhoods.
On {aan} {city} callout we start by inspecting the condition and the operation together, because a gate that binds is often telling you something about its posts rather than its hardware.
If the bones are sound, we fix the bones. Full replacement only makes sense when repair would cost more than it is worth.
We work throughout Burbank and the surrounding Los Angeles County communities. You get a written price before any work begins, and we tell you plainly if replacement is the better value.
Driveway gates carry more weight and travel further than anything else on the property, so they are the first thing to show a problem when a post moves.
We check the posts, the frame, the running gear and the operator together, because a gate this size will not stay fixed if only one of them is right.
Sliding systems fail gradually. The gate gets noisier, then slower, then it starts stopping halfway and reversing.
Catching it at the noise stage is far cheaper than catching it after the operator has burnt out trying to shift it.
A swing gate that has started catching on the driveway is usually a post problem, not a hinge problem.
We fix the cause at the post, then re-hang and re-align so the leaf swings clear and latches cleanly again.
Automatic gates around Burbank combine a physical gate with mechanical and electrical equipment. When one stops working the problem is not necessarily the gate itself — it may be the operator, motor, controls, sensors, remotes, safety equipment or wiring.
The operator opens and closes an automated gate. On a busy Burbank driveway that is hundreds of cycles a month, and they eventually develop mechanical or electrical problems.
We service gates for apartment buildings, businesses and parking areas across Burbank, where a gate that fails is a problem the same morning.
Safety sensors, keypads, remotes, receivers and intercoms all have to agree with each other. We troubleshoot the complete system rather than swapping parts.
Wood gates split, warp and loosen in the Los Angeles County sun. Metal gates develop alignment problems, damaged hardware or failures at welded joints.
From a walk gate that no longer latches to a large automatic entrance, we repair gates on Burbank homes and multifamily property alike.
Burbank covers a lot of ground and a lot of building eras, and every one of them fenced its lots differently. One company for the fence, the gate and the electrics keeps the job simple and keeps responsibility in one place.
Payless Fence Repair & Gate Contractor serves customers throughout Burbank and the surrounding communities. Whether you need a damaged gate repaired, an automatic system diagnosed, a fence line restored, or honest advice about whether repair or replacement makes more sense, the objective is the same: a practical solution and workmanship that lasts.
You get a written price before any work begins, and we tell you plainly if replacement is the better value.
Left alone on {aan} {city} driveway, a dragging gate wears its own track, chews through rollers and eventually damages the frame it hangs on.
We are a locally owned and operated company serving Burbank and the rest of Los Angeles County. Our technicians are trained, experienced and committed to quality workmanship.
Dependable results and long-lasting repairs you can count on. From quality parts to expert workmanship, we take pride in every job we complete in Burbank.
Most jobs start the same way: we walk the line with you, look at what is already there and find out what is actually failing. On a Burbank property that usually means checking the posts before anything else, because a fence almost always gives up at ground level long before the boards do.
The visible part of a fence is the cheap part. What we spend time on in Burbank is the posts, the footings and the framing, because those are what decide whether the run is still straight in ten years.
Price comes down to size, material, access and what has to come out first. A straight run on flat ground with a driveway beside it is quick. The same job down a narrow side return with a hedge in the way is not.
There is no useful phone price for this. What moves the number is the length, the height, the ground conditions and whether there is an old fence or gate to remove. We look, then we put it in writing.
Santa Ana winds do the visible damage. A solid privacy fence is a sail, and all of that load goes into the posts, which is why a footing that seemed fine for years fails in one October night.
Sun is the quiet killer here. UV breaks the surface down and greys the timber, which is cosmetic at first and structural eventually. Sprinklers are worse: a head throwing onto the boards keeps them permanently damp at the base.
You get a straight answer on the day. If the job needs something we cannot do well, we will tell you that too rather than take it on and hope.
We come out and look, we tell you what we found, and you get the price in writing before anything starts. If we think replacement is better value than repair, we say so.
Replacement makes sense when several posts have gone along the same run, when the frame has racked out of square, or when repeated repairs have already cost more than half the price of new. Short of that, repair almost always wins.
We would rather fix what you have than sell you something new. Telling a Burbank customer their fence has years left in it is a shorter conversation, but it is the one that gets us called back.
We cover Burbank and the surrounding communities including Toluca Lake, Universal City and Cahuenga Pass, so we are rarely far away when something needs looking at quickly.
Most of our work is within a short drive of Burbank — Toluca Lake, Universal City, Cahuenga Pass and the rest of Los Angeles County. We are not sending someone across the county to look at your fence.
A straightforward residential run is usually a day or two on site once materials are in. Posts go in first and the concrete needs time before anything hangs on them, so the work is not continuous.
Most fence jobs are measured in days rather than weeks. What stretches a schedule is removal of what is already there, difficult access, or ground that fights the digger.
We match material, spacing and finish as closely as we can. New timber next to weathered timber will not be an exact match until it has aged a season, and we will say so up front rather than after.
It varies with the season. Wind and rain months are busier because more people are calling about damage. We give you a realistic date rather than an optimistic one.
Usually, yes. That is one of the advantages of a fence over a panel system — boards, rails and individual posts can be replaced without touching the rest of the run.
Every pin is a city we cover. Tap one to open our fence contractor page for that city, or see the full list of service areas.
The 20 communities closest to Burbank that we cover. Same crew, same pricing.
(213) 282-7990
Text Us