Looking for Burbank Wood Fence Contractor? We build wood fences for the climate rather than the catalogue: posts set to depth, gravel at the base, a cap rail to keep water off the end grain. We serve Burbank and the surrounding neighborhoods.
No two jobs in {city} are quite the same. One property needs an hour of adjustment and new hardware; the next has shifted posts, a bent frame and an operator that has been fighting the gate for years.
If the bones are sound, we fix the bones. Full replacement only makes sense when repair would cost more than it is worth.
We work throughout Burbank and the surrounding Los Angeles County communities. We give you the price in writing up front, and we do not start work until you are happy with it.
The bigger the gate, the less forgiving it is. A driveway gate that is a fraction out of square will fight its operator every single cycle.
We square the frame, reset what needs resetting and replace worn running gear, then set the operator to suit the gate as it now sits.
A sliding gate is only as good as the track it runs on. Debris, a settled footing or one worn roller is enough to stop a heavy gate dead.
We clean and check the track, replace worn wheels and guides, and reset the limits so the gate stops where it should.
Everything on a swing gate hangs off two hinges and one post. When that post moves even slightly, the far edge of the gate moves a lot.
We reset or replace posts, re-hang the leaf square, and fit hardware rated for the actual weight of the gate.
Automatic gates around Burbank combine a physical gate with mechanical and electrical equipment. When one stops working the problem is not necessarily the gate itself — it may be the operator, motor, controls, sensors, remotes, safety equipment or wiring.
Wood gates split, warp and loosen in the Los Angeles County sun. Metal gates develop alignment problems, damaged hardware or failures at welded joints.
From a walk gate that no longer latches to a large automatic entrance, we repair gates on Burbank homes and multifamily property alike.
We service gates for apartment buildings, businesses and parking areas across Burbank, where a gate that fails is a problem the same morning.
Safety sensors, keypads, remotes, receivers and intercoms all have to agree with each other. We troubleshoot the complete system rather than swapping parts.
The operator opens and closes an automated gate. On a busy Burbank driveway that is hundreds of cycles a month, and they eventually develop mechanical or electrical problems.
Property in Burbank ranges from long-established streets to recent builds, and what is already in the ground varies enormously. Working with a local contractor familiar with wood gates, metal gates, pedestrian gates, driveway gates, sliding systems, swing systems and automatic operators gives you one point of contact for a wide variety of problems.
Payless Fence Repair & Gate Contractor serves customers throughout Burbank and the surrounding communities. Whether you need a damaged gate repaired, an automatic system diagnosed, a fence line restored, or honest advice about whether repair or replacement makes more sense, the objective is the same: a practical solution and workmanship that lasts.
We give you the price in writing up front, and we do not start work until you are happy with it.
A leaning post pulls on everything attached to it, and {city} ground moves enough through the year to start one. What starts as one loose post ends up as a whole section that has to come out.
We are a locally owned and operated company serving Burbank and the rest of Los Angeles County. Our technicians are trained, experienced and committed to quality workmanship.
Dependable results and long-lasting repairs you can count on. From quality parts to expert workmanship, we take pride in every job we complete in Burbank.
Santa Ana winds do the visible damage. A solid privacy fence is a sail, and all of that load goes into the posts, which is why a footing that seemed fine for years fails in one October night.
Sun is the quiet killer here. UV breaks the surface down and greys the timber, which is cosmetic at first and structural eventually. Sprinklers are worse: a head throwing onto the boards keeps them permanently damp at the base.
We match material, spacing and finish as closely as we can. New timber next to weathered timber will not be an exact match until it has aged a season, and we will say so up front rather than after.
If the structure is sound we repair it. Posts that are still solid, a frame that is still square and hardware that can be replaced usually add up to a repair rather than a rebuild.
Replacement makes sense when several posts have gone along the same run, when the frame has racked out of square, or when repeated repairs have already cost more than half the price of new. Short of that, repair almost always wins.
Most of our work is within a short drive of Burbank — Toluca Lake, Universal City, Cahuenga Pass and the rest of Los Angeles County. We are not sending someone across the county to look at your fence.
We cover Burbank and the surrounding communities including Toluca Lake, Universal City and Cahuenga Pass, so we are rarely far away when something needs looking at quickly.
There is no useful phone price for this. What moves the number is the length, the height, the ground conditions and whether there is an old fence or gate to remove. We look, then we put it in writing.
We quote after seeing the property, always. Anyone giving you a firm figure without knowing your ground is guessing, and that guess is rarely in your favour once they arrive.
It varies with the season. Wind and rain months are busier because more people are calling about damage. We give you a realistic date rather than an optimistic one.
Yes. Removal and disposal is priced as part of the job rather than sprung on you at the end, and it is a real cost when there are concrete footings to break out.
Most jobs start the same way: we walk the line with you, look at what is already there and find out what is actually failing. On a Burbank property that usually means checking the posts before anything else, because a fence almost always gives up at ground level long before the boards do.
The visible part of a fence is the cheap part. What we spend time on in Burbank is the posts, the footings and the framing, because those are what decide whether the run is still straight in ten years.
Most fence jobs are measured in days rather than weeks. What stretches a schedule is removal of what is already there, difficult access, or ground that fights the digger.
A straightforward residential run is usually a day or two on site once materials are in. Posts go in first and the concrete needs time before anything hangs on them, so the work is not continuous.
Every pin is a city we cover. Tap one to open our wood fence contractor page for that city, or see the full list of service areas.
The 20 communities closest to Burbank that we cover. Same crew, same pricing.
(213) 282-7990
Text Us